Structural Specification
Woven fabric density evaluation compares warp and weft thread frequencies against target design geometry before wet finishing treatments alter fabric dimensions. In raw grey linen cloth inspection at Heilongjiang weaving facilities, greige sett count defines the number of warp ends and weft picks contained within a specific linear unit directly off the loom. Loom reed width and take-up gear ratios dictate this density prior to desizing, scouring or bleaching operations.
Accurate measurement verifies that structural specifications meet mill production plans.
Weaving Parameter
Loom setup parameters directly dictate raw fabric density and determine how much grey cloth width will shrink during subsequent wet finishing steps. High greige sett count values increase mechanical friction during weaving, requiring higher yarn tenacity to avoid warp thread breakage. If the weft insertion density strays from specified limits, fabric weight and air permeability move outside acceptable tolerance bands.
Quality controllers use counting glasses to verify thread counts at five locations across the woven roll to detect reed spacing errors or fill insertion irregular feeding. Adjusting temple tension and backrest position helps maintain consistent sett across the entire cloth roll.
Quality Document
Mill loom state inspection sheets detail warp and weft density measurements for every freshly woven roll. The recorded greige sett count serves as the technical baseline for calculating finish shrinkage allowances prior to batch release.