Thermal Energy Recovery
Heat exchange systems recycle the latent heat from evaporated steam to drive the evaporation process with minimal external energy input. In the caustic recovery plants of linen mills, mechanical vapor recompression uses a centrifugal fan or a high speed compressor to increase the pressure and temperature of the vapor. This compressed steam then acts as the heating medium for the same liquid it was evaporated from.
The resulting closed loop reduces the demand for live steam from the boiler house.
Caustic Recovery System
Recovery of sodium hydroxide from the mercerization wash water depends on the concentration of the dilute liquid to a reusable density. Through the use of mechanical vapor recompression, the mill can concentrate the weak lye back to the twenty five or thirty percent strength needed for the treatment of linen fabric. This process is more efficient than multi-effect evaporation because it does not require a large cooling water circuit.
The electrical energy consumed by the compressor is far lower than the thermal energy recovered from the vapor. Maintaining the purity of the incoming wash water prevents the scaling of the heat exchanger tubes.
Operational Pressure Limit
Efficiency of the system remains high only when the boiling point rise of the liquid stays within the mechanical limits of the compressor. If the concentration of dissolved solids in the caustic liquor becomes too high, the temperature difference required for evaporation exceeds the capacity of the mechanical vapor recompression unit. The system reaches a boundary where the mechanical stress on the compressor blades and the risk of surge prevent further concentration.
At this point, the recovery process must transition to a different technology or finish the concentration in a small finisher evaporator.