Loom Interruptions
Machine down-time caused by yarn failures during weaving is a primary measure of yarn runnability on the loom. The warp stoppage rate records the number of times a loom stops per hour due to warp thread breakages. Mill supervisors track this metric on shift reports to evaluate the quality of incoming flax yarn beams and the performance of the sizing department.
Fiber Preparation
Low-quality flax with short fibre lengths or poor spinning consistency increases the frequency of weak spots in the yarn. This results in a high warp stoppage rate, because the yarn cannot withstand the cyclic tension of the shedding and beat-up mechanisms. Sizing the yarn with starch or polyvinyl alcohol is the standard method used to reinforce these weak areas before weaving.
When the sizing process is run correctly, the warp threads gain the necessary tensile strength to resist the mechanical stresses of the loom.
Production Throughput
High stop frequencies lead to direct losses in fabric output and increase the labor load on the loom operators. A low warp stoppage rate is critical for maintaining high efficiency on automated rapier and air-jet looms running export-grade linen. Each stop also creates a risk of starting marks on the fabric, which can cause the entire roll to be rejected by the buyer’s quality inspectors.
Minimizing these stops is therefore the main focus of mill optimization programs.