Fibre Sorting
Graded flax yield forms the precise benchmark against which a strick bundle is measured upon arrival at the sorting floor of a Chinese spinning mill. Workers draw a handful of hackled material from the bulk supply and tie the upper portion with a hemp ribbon to form the traditional bundle shape. This prepared unit allows classifiers to assess line quality by pulling individual stalks to check tensile strength and natural colour uniformity.
Mill operators record the resulting grade on the batch docket before the material moves to the wet spinning line.
Tensile Evaluation
Breaking load parameters determine whether a prepared strick bundle meets export specifications or gets downgraded for coarser yarn counts. Technicians clamp each side of the unit into a dynamometer to measure the force required to snap the vegetative fibers under standard humidity conditions. Moisture absorption influences the reading because dry flax exhibits brittle fracture behavior while conditioned lots stretch slightly before failure.
The testing protocol requires ten distinct samples from the same lot to establish an average breaking length that satisfies buyer acceptance criteria.
Yarn Conversion
Subsequent processing stages transform the sorted flax strands into fine linen yarn through a series of drafting and spinning steps. Machinery draws out the parallelized fibers from the bundle while operators apply warm water to soften the natural pectins holding the elementary cells together. This drafting action reduces linear density until the strand reaches the target count for weaving high-grade apparel fabric.
Final output consistency depends entirely on the initial uniformity established when the raw material was gathered into its original hand-tied form.