Defect Classification
Standardized visual grading systems categorize un-finished woven cloth based on the frequency and severity of weaving flaws observed on inspection tables. Quality reports assign a greige inspection grade to each mill roll before fabric leaves the weaving shed. The grading scheme covers physical defects including broken picks, coarse threads, oil stains, and mispicks.
Evaluation boundaries stop at chemical finishing defects, which occur downstream during bleaching or dyeing operations.
Penalty Allocation
Certified inspectors pass loom-state linen fabric over illuminated perches running at controlled speeds. Inspectors assign demerit points based on defect length, assigning one point for minor flaws under three inches and four points for major structural faults spanning up to nine inches. The cumulative points per hundred square meters determine the final greige inspection grade assigned to the cloth roll.
Grade A designation permits direct transfer to fine dyeing lines, while Grade B fabric requires manual mending or clipping. Excessively defective rolls falling into Grade C are diverted to industrial utility applications or downgraded for clearance sales. Mill quality systems log defect codes to trace repeating weave faults back to specific looms or weaver shifts.
Buyer Acceptance
Commercial export contracts specify minimum grade thresholds for incoming fabric shipments. Quality certificates detail the greige inspection grade alongside roll lengths and fabric weights. Conforming fabric rolls meet buyer delivery requirements for downstream wet processing.