Cycle Synchronization
Looms coordinate the crossing of the warp sheets with the beat-up action of the reed to lock the inserted weft thread into the fabric structure. This crucial event in the manufacturing cycle is called the shed crossing point, and it is measured in degrees of the crankshaft rotation. In linen fabric production, this point is often set before or after the beat-up to control the tightness of the interlacing pattern and prevent warp breakages.
Setting this parameter requires careful consideration of the yarn type and fabric density. This adjustment is documented in the loom’s electronic setup profile.
Tension Distribution
Warp yarn tension peaks when the harnesses are fully open, but it drops to its lowest level when the warp sheets are aligned in a single plane. The shed crossing point determines when this period of low tension occurs in relation to the mechanical impact of the reed. By timing the crossing to occur slightly before beat-up, loom operators can lock the weft yarn in place while the warp yarn is under lower tension.
This protects the flax fibres from being abraded or broken by the reed.
Fabric Appearance
Early crossing prevents the weft yarn from slipping backward after it is beaten into the fabric. This is essential for producing high-density linen fabrics with a smooth and uniform surface.