Moisture Lag
Equilibrium moisture content in flax fibres differs depending on whether the material is approaching that state from a dry or wet condition. The hysteresis moisture regain creates a situation where the absorption curve remains lower than the desorption curve at any given relative humidity level. This property dictates how mills must condition linen to achieve the target weight for commercial sale.
Absorption Path
Pectin and cellulose within the flax cell wall retain water through hydrogen bonding which creates a lag in the release of moisture. Because the internal structure of the fibre rearranges during drying, the sites available for water molecules change. This physical reality means a mill cannot simply rely on ambient humidity to predict the exact weight of a flax bale without knowing its thermal history.
The difference between the two moisture paths can represent up to two percent of the total fibre mass depending on the previous exposure to heat.
Laboratory Calibration
Shipping documents and laboratory reports must account for this discrepancy to ensure fair trade between mills and buyers. Testing standards often require samples to be pre-conditioned at a low humidity before reaching the standard atmosphere to standardise the starting point. This procedure eliminates the uncertainty caused by the path of moisture gain.
Every commercial laboratory in the flax supply chain utilizes these specific protocols to ensure that measurements are comparable across different regions.