Biological Adhesive Matrix
Secretions from microorganisms form a structural network that binds cells together within the sludge of a wastewater treatment plant. In mills processing flax, extracellular polymeric substances act as a natural glue that holds the biological floc together during the aerobic digestion process. These polymers consist of proteins, polysaccharides, lipids and nucleic acids that create a protective environment for the bacteria.
The quantity of these substances determines the density and the settling velocity of the sludge.
Membrane Filtration Resistance
Accumulation of biological polymers on the surface of ultrafiltration units creates a gel layer that blocks the passage of water. During the treatment of linen mill effluent, extracellular polymeric substances migrate to the membrane interface and increase the transmembrane pressure. This layer is resistant to simple hydraulic backwashing because of its high viscosity and adhesive properties.
Chemical cleaning is required to dissolve the organic bonds and restore the flux. Without regular intervention, the filtration capacity of the system drops below the daily volume produced by the spinning lines.
Treatment Protocol Boundary
Precise control of the food to microorganism ratio limits the overproduction of these sticky compounds. If the biological load fluctuates rapidly, extracellular polymeric substances are produced in excess and cause bulking in the clarifier. High levels of these polymers also interfere with the dewatering of the waste sludge.
The moisture content of the resulting cake remains high, which increases the cost of disposal and transport. Effective management of the aeration tank environment maintains the polymer levels within the range necessary for healthy floc formation.