Mechanical Strain
Repetitive tension fluctuations experienced by longitudinal yarns during shed opening and beat-up cycles constitute a primary cause of mechanical degradation in linen weaving. Flax yarns subjected to cyclic warp loading undergo progressive structural breakdown as inelastic bast fibres slip past one another under peak shed openings. A mill tension log records these stress peaks alongside machine speed and loom dwell angles.
Buyer acceptance criteria define permissible yarn break thresholds resulting from these mechanical stresses.
Tension Variation
Peak forces occur twice per pick when the shed reaches maximum height and when the reed forces the wet or dry weft thread into the cloth fell. Continuous peak tensions pull short flax fibres out of the yarn core, which reduces single end strength before beat-up occurs. High loom speeds exacerbate yarn hairiness because loose fibre ends migrate outward during rapid acceleration phases.
Adjusting backrest roller position and drop wire placement mitigates localized peak force concentration across the warp sheet.
Threshold Boundary
Sizing agents applied to flax yarn alter its elasticity profile, shifting the point where permanent deformation occurs under continuous loom motion. Unsized dry-spun linen yarns fail rapidly under lower stress cycles compared to wet-spun wet-finished warp yarns that retain higher axial cohesion. Yarn tension meters measure peak forces across different harness frame settings to establish operational limits for specific yarn counts.
Exceeding recommended tension levels increases warp end breakage rates and creates thin places in the woven grey cloth. Mills log these parameters in daily weaving shed yield reports to verify compliance with buyer quality agreements.