Mechanical Process
Mechanical drawing of parallelized fibrous bundles through pairs of rollers operating at different surface speeds represents the primary method for reducing slippage during yarn preparation. In linen production, bast fiber drafting aligns the individual flax strands to produce a uniform sliver suitable for high-grade spinning. The input sliver undergoes attenuation by the action of drafting rollers, where the front rollers run faster than the back rollers.
This speed ratio determines the draft, which is calculated as the ratio of output speed to input speed and typically ranges from ten to sixty in wet spinning systems. Tight control of the nip point ensures that the longer bast fibers are not crushed or severed during the process.
Drafting Zone
Control over the fiber movement in the draft zone is exercised using faller bars or pinned zones. In bast fiber drafting, the irregular lengths of the natural flax fibers demand close control to prevent drafting waves or uneven distribution of density. Proper draft settings are recorded on the spinning mill specification sheet to ensure consistent yarn diameter.
Failure to control the fibers results in thick and thin places.
Quality Impact
Yarn irregularity and subsequent fabric defects can be traced back directly to uneven fiber drafting. When the draft ratio is too high, the fibers are pulled apart unevenly, which leads to weak spots. Testing the yarn for coefficient of variation reveals the efficiency of the drafting process.
Minimizing drafting defects is essential for high-speed weaving looms where weak yarn causes breaks.