Filament Separation
Physical separation of longitudinal yarns under the mechanical stress of a loom results in structural defects within the woven cloth. Warp cleavage happens when the tension applied during the shedding process exceeds the cohesive strength of the individual yarn filaments. This separation creates small gaps or visible splits in the fabric surface that compromise the integrity of the finished linen.
Improving the sizing quality or reducing the loom speed can mitigate this risk. The defect is recorded on the final inspection sheet before the roll is approved for shipping.
Tension Rupture
Yarn strength alone is insufficient to prevent breakage if the distribution of load across the warp beam is uneven. Warp cleavage occurs most frequently during the high-tension phase of the weaving cycle when the heddles pull the yarns apart to create the passage for the weft. If the sizing is too brittle or the yarns contain thick segments, the mechanical resistance increases at the points where the yarns cross.
This localized pressure causes the individual flax fibres to slide past one another, leading to a complete rupture of the yarn strand. Operators use electronic sensors to monitor tension peaks and stop the machine before a break can cause a large flaw. Maintaining the correct relative humidity in the weaving shed helps the flax retain enough moisture to resist these sudden stresses.
Loom Mechanics
Mechanical settings on the weaving machine control the height and timing of the shed opening to minimize stress on the yarn bundles. Warp cleavage is often exacerbated by excessive lift or an unbalanced tension between the upper and lower layers of the warp. Adjusting the back-rest position reduces the peak load during the beat-up phase.
These calibrations ensure that the fabric maintains a uniform density across the entire width of the loom.