Linear Mass Fluctuation
Continuous variability in material weight per unit length describes the uneven distribution of fibrous mass along an unspun textile strand. In flax processing, sliver mass unevenness quantifies the cross-sectional mass variation present in carded or hackled line bundles after drawing and doubling passes. The metric identifies periodic and random weight deviations that, if left uncorrected, propagate directly into cyclic thin and thick defects in the final yarn.
Measurement parameters apply strictly to untwisted, continuous slivers and rovings, terminating when twist insertion consolidates the structure into yarn where structural geometry alters mass testing behavior.
Capacitive Waveform Analysis
Unevenness testing routes the conditioned sliver through the high-frequency electric field of a capacitive sensor slot at constant speed. Variations in fibre mass change the sensor capacitance, generating an analog signal that software translates into percentage values. The resulting output yields two primary indices, the percentage unevenness U and the coefficient of variation of mass, known as CVm.
A spectrogram accompanying the test traces these mass fluctuations across specific wavelengths, revealing mechanical defects within the drawing frames. Short-wave mass peaks indicate worn drafting flutes or incorrect roller pressures, whereas long-wave variations point to poor doubling balance or improper sliver feeding at the creel. Unprocessed flax bundles resist consistent drafting because natural pectins cause bundle slippage to occur in clusters rather than individual cell progressions, elevating baseline unevenness compared to synthetic or cotton slivers.
Downstream Impact Assessment
Technical laboratories log CVm percentages and spectrogram traces onto the internal drawing quality report for every drawing passage. Sliver mass unevenness must drop progressively through the primary, secondary, and tertiary drawing passages, where doubling multiple ends averages out upstream carding irregularities. If a finisher sliver displays a CVm exceeding six percent on line flax, it fails mill release standards and cannot proceed to the roving frame.
Running high-variance sliver through roving frames produces roving with localized drafting weak spots, ultimately triggering frequent yarn breaks on wet ring frames and creating visible horizontal tiger stripes across woven fabric. Raw material suppliers receive claims if uncombed flax bundles possess erratic bundle divisions that resist regular drafting despite standard drawing machine settings.