Roller Geometry
Mechanical spacing between drafting roller nips governs fibre attenuation during yarn preparation. On flax wet spinning frames, drafting roll settings determine ratch distance and clamping pressure applied to bundle slivers. Technicians adjust back-roll and front-roll positions based on mean technical fibre length measured after hackling.
The physical setup fails to produce uniform sliver when fibre length distribution becomes excessively bimodal or contains un-retted shive particles.
Nip Pressure
Pressure distribution across top rubber drafting rollers dictates grip stability over wet bast bundles. Spinning mill logbooks record roller hardness in Shore durometer units and spring loads in decanewtons per nip position. Insufficient nip clamping permits bundle slippage, generating heavy slubs and un-drafted strand segments in finished yarn.
Over-clamping crushes delicate flax fibres, reducing filament tenacity and raising end-break frequency during fine count spinning.
Attenuation Limit
Slippage control limits the maximum draft ratio achievable across a single drafting zone without introducing drafting waves. Mill technicians set ratch distances slightly longer than the longest fibre fraction to prevent filament breakage during attenuation, documenting these parameters on mill floor setup sheets. When processing lower-grade flax with variable fiber length, incorrect nip distances create yarn thick places that fail buyer visual standards.
Fine count wet spinning demands precise alignment between ratch length and bundle cohesion to prevent yarn count drift across spinning shifts. Continuous monitoring of drafting geometry ensures that target yarn count and tenacity remain consistent across large export production runs.