Sizing Fault
Unwanted residual chemical agents or protective starch coatings that remain on warp yarns after the washing phase prevent uniform penetration of dyes and finishing agents. This desizing resist condition occurs when the enzymes or acids fail to fully break down the protective sizes applied during fabric preparation. The resulting barriers lead to uneven color distribution and blotchy areas in the finished linen fabric.
Chemical Cause
Sizing compounds like polyvinyl alcohol or starch are applied to flax yarns to increase their strength and reduce breakage on high-speed looms. If the desizing bath lacks the correct temperature or enzyme concentration, these compounds do not dissolve completely and cling to the yarn. When the fabric enters the dyeing machine, the remaining starch acts as a shield that blocks dye molecules from reaching the cellulose fibres.
This incomplete removal usually results from hard water or poor surfactant wetting on the dense linen structure.
Fault Detection
Technicians apply an iodine solution to fabric samples, which produces a deep blue color if residual starch is present. This rapid test allows operators to adjust the washing parameters or re-run the fabric through the desizing line before proceeding to further treatments. Corrective re-washing prevents costly fabric rejection and ensures consistent dye uptake across the batch.