Instrument Standardisation
The systematic correction of an instrument’s blank run profile ensures that any measured changes in heat flow or mass are due solely to the sample rather than to the thermal characteristics of the empty furnace. This process, referred to as thermal baseline calibration, accounts for the buoyancy effect of the purge gas and the asymmetric heat transfer within the heating chamber of a thermogravimetric analyzer. If the baseline is not calibrated, the buoyancy forces can mimic a weight gain or weight loss, distorting the analytical curves of natural fibres.
Regular execution of this correction maintains the accuracy of quantitative measurements.
Calibration Procedure
The calibration procedure involves running empty crucibles through the entire temperature program under the exact same gas flow and heating rate as the planned test runs. This recorded signal is then subtracted from the subsequent sample runs, yielding a flat baseline that represents zero net weight change. When executing a thermal baseline calibration, the laboratory must use the same purge gas, such as nitrogen or air, to ensure that the gas density and thermal conductivity match the testing conditions.
Any change in the gas flow rate requires a new calibration run to prevent baseline drift.
Precision Impact
Having a highly stable and flat baseline is vital for detecting the subtle mass changes that occur during the early stages of flax fibre degradation. In these initial phases, the evaporation of bound water and the release of minor volatile compounds are easily masked by a drifting baseline. By implementing a rigorous thermal baseline calibration, the spinner can measure these low-temperature transitions with high precision, obtaining accurate figures for moisture content and finish-on-fibre oils.
This precision enables the mill to optimize the scouring and drying of flax fibres, protecting the raw material from thermal damage while ensuring maximum yield during spinning. It also ensures that the high-temperature ash determination remains free from instrument-induced measurement errors, reinforcing the validity of the final quality reports.