Fiber Contraction
Boiling and chemical extraction of linen roving on perforated bobbins causes a physical reduction in the length of the wound strand. This change, designated as roving extraction shrinkage, occurs as pectins are removed from the flax fiber during scouring. Spinning facilities measure this contraction to adjust the winding tension.
Structural Impact
Dense winding prevents the uniform flow of chemical solutions through the roving package during treatment. If roving extraction shrinkage is too high, the yarn on the inner layers of the bobbin becomes compacted and cannot be drafted evenly during wet spinning. This compaction leads to irregular yarn diameter and reduces the strength of the finished linen fabric.
Proper tension control on the flyer frame ensures that the package retains enough elasticity to accommodate the contraction without locking the fibers.
Production Measurement
Quality control laboratories determine the contraction rate by measuring a ten-meter strand of roving before and after a standard scouring cycle. This calculation yields a percentage that guides the setup of the spinning frame drafting zone. Typical values for high-quality flax range between three and five percent.
Variations outside this range signal inconsistencies in the raw fiber retting or the chemical concentration of the scouring bath. Regular measurement prevents downstream drafting issues where tight fibers resist elongation and cause frequent yarn breakages on the ring frames.