Defect Assessment
An evaluation metric in textile quality control assigns the maximum allowable deduction for severe localized structural damage. A hole penalty represents a specific point deduction, typically the maximum of four points under the standard four-point system, applied whenever yarn breakage leaves an opening in the fabric. This assessment is applied to finished linen cloths destined for high-end garments where any open puncture renders the immediate area unusable.
It is limited to actual ruptures of the woven structure and does not apply to simple thin spots or minor yarn irregularities.
Grading Practice
Inspectors operating under international standards like ASTM D5430 record these severe defects on a dedicated tally sheet during roll evaluation. Because a hole penalty represents a complete loss of that specific yardage, inspectors operate with high vigilance. Mill staff must flag these locations with colored tags in the fabric selvage to alert the cutting room of their presence.
If a single roll accumulates too many of these severe point assignments, the entire lot is downgraded to second quality fabric.
Inspection Boundary
Linen buyers use the hole penalty to ensure that garments are not cut from damaged fabric yards. If the opening is smaller than this limit, it may be graded as a lesser defect depending on inspector judgment. Woven linen contracts specify the point limit per hundred linear yards before the shipment is rejected.